JAI TM-2016-8/8CL - Manual (Page 22)

Page 12
TM-2016-8 and TM-2016-8CL Progressive Scan Shutter Camera
Installation
2.2.6 Camera Link Cable (TM-2016-8CL only)
The Camera Link cable assembly (26CL-02-26) has a 26-pin MDR26 connector on both ends. This is a
straight-through cable. The pin-out configuration is shown in Table 4 on page 9.
Note: For the TM-2016-8CL model, serial communication for camera control is done via the
Camera Link connector on the rear panel of the camera.
2.2.7 Power Supplies and Power Cable Setup
2.2.7 (a) Power Supplies
The TM-1402 requires 12V DC power that is obtained through the 12-pin connector located on the rear
panel of the camera. JAI, Inc. recommends the following power supplies:
PD-12UU 100-240V AC/12V DC 1.2A universal voltage power supply with
(No 12-pin connector) US plug
PD-12UUP 100-240V AC 1.2A universal voltage power supply with US plug
and 12-pin connector
PD-12UE 100-240V AC/12V DC 1.2A universal power supply with European plug
(No 12-pin connector)
PD-12UEP 100-240V AC/12V DC 1.2A universal power supply with European plug and
12-pin connector
If you are providing power through the 12-pin connector, the PD-12UUP and PD-12UEP power
supplies are available with the 12-pin mating connector already attached to the leads from the power
supply. The PD-12UU or PD-12UE power supply can be connected to the JAI, Inc. power cable either
directly or via a terminal strip.
When wiring the PD-12UU power supply directly, please note the following:
• The lead ends must be twisted together and tin-soldered for strength and electrical continuity.
• Shrink tubing or a similar insulator should be used to prevent exposed leads from touching and
shorting.
• The +12V lead is marked with a red stripe or white lettering; be sure not to reverse the leads.
• All connections must be properly insulated to prevent shorting.
2x
Thumbscrews
2x
Thumbscrews
Cable
26 Position
High Density
Mini D Ribbon
(MDR) Male Plug
26 Position
High Density
Mini D Ribbon
(MDR) Male Plug