Silvercrest WAKE-UP LIGHT KH 2600 - Manual (Page 14)

12
Setting up and connecting
KH 2600
GB
IE
Electrical connections
Before connecting the device, compare the connection data (voltage and ■
frequency) on the rating plate of the device with that of your power supply
network. This data must tally in order to avoid damage to the device.
Make sure that the device's connection cable is not damaged and is not ■
laying over hot surfaces and/or sharp edges.
Make sure that the connection cable is not tightly stretched or bent. ■
Do not allow the connection cord to hang over edges (Trip wire eff ect). ■
Inserting back-up batteries
By inserting the batteries you can avoid the loss of programmed time of day and
alarm wake time in the event of a possible power outage. The batteries make
sure that the internal clock continues to run even during a power outage. When
power is restored the correct time appears automatically in the display
4 .
NOTICE
The back-up batteries only save the time of day and the programmed wake ►
time. All other functions are only possible with mains power operation.
The device can also be operated without batteries. ►
Slide the access cover of the battery compartment ¡ 26 on the underside of
the device in the direction of the arrow and remove the access cover.
Insert 2 batteries type AA (supplied) into the battery compartment. Make ¡
sure that you observe the polarity as depicted in the battery compartment.
Close the battery compartment by replacing the access cover, slide back in ¡
and allow it to lock into place.