Silvercrest WAKE-UP LIGHT KH 2600 - Manual (Page 16)

14
Handling and operation
KH 2600
GB
IE
Handling and operation
In this chapter you receive important information for the handling and operation
of the device.
Switching On and Off
Press the ¡ /ALARM OFF button 20 or the button on the remote control
to switch the device on. The display 4 is activated.
Press the ¡ /ALARM OFF button 20 or the button on the remote control
to switch the device off . In the display 4 is shown the time of day, the
temperature and a programmed alarm time (Standby mode).
NOTICE
The ► /ALARM OFFbutton 20 does not completely disconnect the device
from the mains power. To completely disconnect the device from the mains
power the mains power cable plug
23 must be pulled from the mains socket.
Setting the time
Prerequisite: The device is in standby mode.
Press the MEMORY/TIME button ¡ 17 or the TIME button on the remote
control. The hour indicator in the display 4 blinks.
Press the SLEEP button ¡ 14 for approx. 2 seconds to switch between the
12h/24h time of day display.
Set, with the ►►I button ¡ 11 or the I◄◄ button 13 , the current time of day
hour. With each button press the time changes by one hour. Holding down
the respective button for more than 2 seconds starts the speed setting.
Press the MEMORY/TIME button ¡ 17 or the TIME button on the remote
control. The minute indicator in the display 4 blinks.
Set, with the ►►I button ¡ 11 or the I◄◄ button 13 , the current time of day
minutes. With each button press the time changes by one minute. Holding
down the respective button for more than 2 seconds starts the speed setting.
Press the MEMORY/TIME button ¡ 17 or the TIME button on the remote
control to confi rm the time input or wait for approx. 7 seconds after which
the time input will be automatically confi rmed.
NOTICE
The time of day will revert back to 0:00 o'clock if the device is disconnected ►
from the mains power supply with no back-up batteries inserted or if the
back-up batteries are too weak.