Silvercrest WAKE-UP LIGHT KH 2600 - Manual (Page 23)

21
Handling and operation
KH 2600
GB
IE
Alarm Function
When setting the wake time you confi gure the light intensity, the wake sound
and the volume. In the 30 minutes before the set wake time the light intensity
increases slowly to the selected level. When the set wake time is reached the
sound level increases, within 90 seconds, slowly to the selected volume.
Programming alarm wake times
The device has two alarms available. All settings for both alarms can be carried
out independently from each other. You can choose whether, at the programmed
time, an alarm tone or a variety of nature sounds should be played, whether
the radio should sound out or music from an iPod/iPhone or an external audio
device should be played.
Prerequisite: The device is in standby mode.
Press the ALARM1/DOWN button ¡ 18 /
ALARM2/UP button 16 on the device or the
AL1/AL2 button on the remote control. The hour
indicator in the display
4 blinks.
Set with the ►►I button ¡ 11 or the I◄◄ button 13
the hour. With each button press the time changes
by one hour. Holding down the respective button
for more than two seconds starts the speed setting.
Press the ALARM1/DOWN button ¡ 18 /
ALARM2/UP button 16 on the device or the
AL1/AL2 button on the remote control. The
minute indicator in the display
4 blinks.
Set with the ►►I button ¡ 11 or the I◄◄ button
13 the minutes. With each button press the time
changes by one minute. Holding down the re-
spective button for more than two seconds starts
the speed setting.
Press the ALARM1/DOWN button ¡ 18 /ALARM2/UP button 16 on the
device or the AL1/AL2 button on the remote control again to confi rm the
setting.