Silvercrest WAKE-UP LIGHT KH 2600 - Manual (Page 22)

20
Handling and operation
KH 2600
GB
IE
Reading lamp
You can use the device as a reading lamp.
Press the ¡ button 19 on the device or on the remote control to switch the
lamp on and off .
Press the ¡ / button to set the brightness. The symbol and the
light intensity (00 to 20) are shown in the display 4 .
NOTICE
If you have set the light intensity to 00 you can, by all means, set a higher ►
value, the lamp remains, however, switched off and must be switched back
on via the
button 19 on the device or on the remote control.
The light intensity that you have selected will also be saved automatically ►
as the light intensity for the wake function.
Replacing the halogen lamp
The halogen lamp 2 must be replaced if it is defective or the light intensity
decreases.
DANGER
Risk of fatal electrocution!
Pull the plug from the mains socket before you change the halogen lamp ► 2 .
NOTICE
The halogen lamp ► 2 must only be replaced with one of the same lamp
type: E27 42 W.
Turn the lamp housing ¡ in the direc-
tion of the arrow and lift it upwards.
Unscrew the defective halogen lamp ¡
from the lamp socket.
Screw a new 42 W halogen lamp into ¡
the lamp socket.
Place the lamp housing ¡ carefully
from above and turn it in the opposite
direction to the arrow to attach.