Setting up and connecting, Activating the remote control battery, Changing the remote control battery – Silvercrest WAKE-UP LIGHT KH 2600 User Manual
Page 15: Providing mains power, Vhf wire antenna, Connecting the headphones
13
Setting up and connecting
KH 2600
GB
IE
Activating the remote control battery
The remote control battery is already inserted when delivered.
Activate the battery by removing the isolation strip.
¡
Changing the remote control battery
Press, with the fi ngernail, the recess (A) to the right
¡
and, at the same time, pull the battery compartment
out.
Insert a 3 V battery type CR 2032 in the battery
¡
compartment. The side with the marking "+" points
upwards.
Slide the battery compartment completely back into
¡
the remote control.
Providing mains power
Place the device approx. 40 to 50 cm away from your head (i.e. on the
¡
bedside table).
Plug the mains power plug into a wall socket. In the display
¡
4
the time of
day (0:00 o'clock) and the temperature will be shown.
VHF wire antenna
For VHF reception completely unfold the wire antenna
¡
24
.
Connecting the headphones
If required you can connect headphones (with a 3.5 mm jackplug) to the
¡
connection socket
21
on the rear panel of the device. The speakers then
switch off automatically.