SATO MB400I User Manual
Page 10
Preparing for First-time Operation
4
19
Preparing for First-time Operation
4
18
Dispense mode printing
Label paper
Non-separated labels
(See figure on P. 40)
Label guide stopper
5
Check that the label tip is
protruding. Then close the main
cover by pressing the middle of
the cover.
Close the main cover slowly, while
pulling the cover release lever.
4
Confirm that the label roll can be
rotated easily by hand.
If rotation is labored, this can cause a
feed error. Remove the label roll and
adjust the label guide. Note that the
label guides do not require adjustment
when you are using labels with the
same width.
This completes loading the labels for continuous printing mode.
1
Slide the cover release lever in
the arrow direction to open the
cover.
First, slide the dispenser unit to the
continuous printing mode position. (See
P. 21)
* Never slide the dispenser unit while
the main cover is open.
2
While pressing the label guide
stopper, slide the label guide to
the label size to be used.
3
Peel the label at the tip of the
label paper.
Dispense mode printing is not required
for non-separated labels.