SATO MB400I - Manual (Page 8)

Preparing for First-time Operation
4
15
Preparing for First-time Operation
4
14
Installing and Removing the Battery Pack
Battery pack Hook
Terminal
Handle
Charging time
It takes about 5 hours for the battery remaining power display to turn off when
charging a completely depleted battery.
1 Remove the DC input terminal
cover, and insert the DC output
terminal.
• Charging by installing the specialized AC adapter (optional) on the printer
This charges the battery pack while it is installed in the printer.
DC output terminal
AC adapter
DC input terminal
The AC adapter set provided for this printer is specific to this printer. Do not use it
for other electric equipment.
Note
• When the CHARGE lamp is not lit, check that the battery pack is installed securely.
The battery may not be charged when not securely installed.
• When a charged battery pack is installed, the CHARGE lamp first lights red, then lights
green.
2 Plug the AC adapter into the
outlet.
When charging begins, the battery life
indicator lights red. When charging is
complete, the battery life indicator
disappears (fully charged).
* On a wireless LAN interface
operating panel (manufacturer
option), the CHARGE LED lights
red when charging begins. When
charging is complete, the CHARGE
LED turns off (fully charged).
1
Open the battery cover.
2 While pressing the gray hook,
insert the battery pack, then
close the battery cover.
Insert the battery pack with the terminal
side toward the printer.
3 To remove the battery, press the
gray hook to unlock it, then hold
the handle and pull out the
battery.
* Be sure to turn the power off before removing or replacing the battery
pack.
When the power is off, the STATUS LED turns off (see “Power OFF” on
page 22). Do not remove the battery pack until this light turns off.
Make sure to check that the STATUS LED has turned off before
removing the battery pack.
* Note that removing the battery pack by the operation above may
prevent updating the information in the printer memory.