SATO MB400I - Manual (Page 24)

Reference
14
47
Reference
14
46
Operation
The following control codes are set as
standard codes.
The following control codes are set as
non-standard codes.
* Non-standard codes can be changed using
the user download setting command.
Standard/non-standard code setting mode
Standard code/non-standard code settings for control codes can be changed using the
control code setting command.
Change standard/non-standard code setting
The standard code/non-standard code setting is changed by the DIP switch (DSW) settings
when the power is turned on, and by button settings. The settings are enabled upon turning
the power off.
Note: When the buzzer sound mode is enabled, the buzzer sounds upon startup. Release
the PRINT/FEED button to stop the buzzer.
To check the settings for the standard code/non-standard code setting mode, see
the test print output (See P. 23).
To end standard code/non-standard code setting, confirm that the STATUS LED is
on in green, then turn power off. After changing the standard code/non-standard
code setting mode, be sure to restore the DSW to their original settings.
1 Non-standard code setting
DSW-1,2,3,4=(ON,ON,OFF,ON) + cover open + PRINT button + POWER
2 Standard code setting
DSW-1,2,3,4=(ON,ON,OFF,ON) + cover open + FEED button + POWER
Processing setting
(STATUS LED flashes green)
Setting completes
(STATUS LED lights green)
Type
Standard code setting
Non-standard code
setting
Default
Standard code
setting
Standard/non-standard specifications
Control code Binary
STX 02H
ETX 03H
ESC 1BH
ENQ 05H
CAN 18H
NULL 00H
Control code Binary
STX 7BH({)
ETX 7DH())
ESC 5EH(^)
ENQ 40H(@)
CAN 21H(!)
NULL 7EH(~)
1 Disable buzzer sound
DSW-1,2,3,4=(OFF,OFF,ON,ON) + cover open + PRINT button + POWER
2 Enable buzzer sound
DSW-1,2,3,4=(OFF,OFF,ON,ON) + cover open + FEED button + POWER
Processing setting
(STATUS LED flashes green)
Setting completes
(STATUS LED lights green)
Note: When the buzzer sound mode is enabled, the buzzer sounds upon startup.
Release the PRINT/FEED button to stop the buzzer. To check the settings for the
buzzer sound setting mode, see the test print output (See P. 23).
To end buzzer sound setting, confirm that the STATUS LED is on in green, then turn
the power off. After changing the buzzer sound setting mode, be sure to restore the
DSW to their original settings.
Change buzzer sound setting
Buzzer sound mode setting
A buzzer can be sounded upon starting up the printer and upon errors. The buzzer is
enabled by default. This can be enabled or disabled by the initial operation and by online
command.