SATO MB400I - Manual (Page 11)

Preparing for First-time Operation
4
21
Preparing for First-time Operation
4
20
10mm
8 Slide the dispenser unit until it
stops. 4 Load the paper in the printer.
Make sure the roll is oriented correctly.
5
Confirm that the label roll can be
rotated easily by hand.
If rotation is labored, this can cause a
feed error. Remove the label roll and
adjust the label guide. Note that the
label guides do not require adjustment
when using labels with the same width.
6 Check that the label tip is
protruding (10 mm or more).
Then close the main cover by
pressing the middle of the cover.
Close the main cover slowly, while
pulling the cover release lever.
7 For non-separated labels, press
the FEED button to feed one
sheet, and pull upward to tear
along the perforated line.
If the labels clog at the label dispenser,
restart the label loading process from
the beginning.
This completes loading of the labels for dispense mode printing.
• Switching from Dispense mode printing to Continuous printing mode
Holding the dispenser/continuous switching lever upward, slide the dispenser unit toward
you. Never pull it with the lever still engaged. This may damage the dispenser unit.
When using dispense mode printing, be sure to follow the procedure above to switch
the dispenser unit from dispense mode printing to continuous printing mode, before
changing the paper.