Preparing the distribution amplifier for use – Symmetricom 58502A User Manual
Page 14
Chapter 1 Getting Started
Preparing the Distribution Amplifier for Use
1-4
User’s Guide
Preparing the Distribution Amplifier for
Use
To Mount the 58502A Into an Equipment Rack (Using
Option AX4)
1
Position the 58502A on your work surface with the front panel facing
you.
2
As shown in Figure 1-1, place the long side of an angle bracket (1), part
number 58502-00004, with its four mounting holes aligned with the
four holes present on the 58502A front side. Note that you may select
the four bracket holes appropriate for either a flush or protruding
installation.
The angle brackets are provide in the Option AX4 Rack Mount Kit.
Figure 1-1. Attaching Mounting Brackets for Equipment Rack
3
Attach the bracket to the instrument using four T-15 TORX
®
screws
(2), part number 0515-0380. These screws are provided in the
Option AX4 Rack Mount Kit.
4
Repeat steps 1 through 3 to attach a bracket to the other side of the
instrument.
5
Place the instrument in the position it will occupy in the equipment
rack (providing support as required while attaching the mounting
hardware). Secure the instrument to the rack with the appropriate
hardware.
SY
ST
EM
S
TA
TU
S
Power
Alarm
Input
A
Input
B
OU
TP
UT
S
TA
TU
S
1
2
3
4
5
6
7
8
9
10
11
12
58502A
DISTRIBUTION AMPLIFIER
1
2