Speco Technologies DVR-16TT - Manual (Page 75)

User’s Manual
DVR-4TN/8TN/16TN/16TS/16TT Series
SPECO TECHNOLOGIES 01/06
74
NOTE:
No any two DVR-4TN/ DVR-8TN/ DVR-16TN series units
should be set the same Host Name.
- DDNS Port
This item allows the user to setup the port for DDNS. Press UP / DOWN
Direction keys to change the port.
- Submit/Update
When done, move the cursor to this item and press ENTER to submit the
settings.
NOTE: If there are two DVR-4TN/ DVR-8TN/ DVR-16TN series units
set with the same domain name, the later setting will not be submit
successfully.
5.1.7 RS485 Setup
This menu allows the user to setup the parameters of the unit’s RS-485
communications port. From the Main menu, select <RS485 Setup> and press
ENTER. The following menu is displayed.
RS485 Setup
1. Unit ID
2. Baud Rate
3. Bits
4. Stop
5. Parity 224
9600
8
1
None
5.1.7.1 Unit ID
This item is used to change the RS-485 ID address of the unit. The ID is with
the range of <1> to <255>. The default is <224>.
5.1.7.2 Baud Rate
The Baud rate options for association with the protocol are <2400>, <4800>,
<9600>, <19200>, <38400> and <57600>. The default is <9600> baud.