1 channel select, 2 video loss detect, 3 motion detect – Speco Technologies DVR-16TT User Manual
Page 93: 4 detection config, Channel select, Video loss detect, Motion detect, Detection config
User’s Manual
DVR-4TN/8TN/16TN/16TS/16TT Series
SPECO TECHNOLOGIES 01/06
92
5.6.6.1 Channel Select
This item is used to select a desired channel for setting the parameters. Move
the cursor to <Channel Select> and press ENTER, then select a channel
using UP / DOWN keys. Press ENTER again to confirm the setting.
5.6.6.2 Video Loss Detect
This item allows the user to enable / disable Video Loss as an alarm event.
Select <ON> to enable Video Loss alarm events, <OFF> to disable. The
default setting is <OFF>.
5.6.6.3 Motion Detect
Use to enable or disable the motion detection function of the
DVR-4TN/8TN/16TN/16TS/16TT
series unit. By default, the value is <OFF>.
If the motion detection function is enabled, it is required to define the motion
detection parameters such as detection area and sensitivity settings.
5.6.6.4 Detection Config
If motion detection function is enabled, it is required to define the motion
detection parameters such as detection area and sensitivity settings. Select a
channel for setting the parameters, move the cursor to <Detection Config>,
and press ENTER. The Detection Configuration menu displays as follows.
Detection Config
1. Detected Area Setup
2. Sensitivity
3. Area Threshold
88%
6%
----- Detected Area Percentage -----
40%
▲