Sony CMT-DH7BT - Manual (Page 75)

CMT-DH7BT.GB.3-097-195-11(2)
 GB
Additional I
nf
or
ma
tion
SIRIUS
ANTENNA
The antenna is not connected properly.
Check the connection between the
SiriusConnect Home tuner and the
antenna.
ACQUIRING
The receiving condition is not good. Try
moving the antenna to another location.
For details about the antenna location,
see the instructions supplied with the
SiriusConnect Home tuner.
Call ––SIRI
You have not subscribed for the selected
channel.
CHECK SIRIUS
The SiriusConnect Home tuner is
not connected properly. Check all the
connections, and then turn the system on
again. Also make sure if the AC adaptor
supplied with the SiriusConnect Home
tuner is connected to a wall socket.
Invalid
You have entered an invalid channel
number. The channel to be tuned-in is
void due to the change by the broadcast
service, or the receiving condition is not
good.
SUB UPDATED
You have not subscribed for SIRIUS or
the channel is not authorized. You need
to subscribe for SIRIUS.
UPDATING
Channel information or SiriusConnect
Home tuner firmware is being updated.
– – – – – –
There is no text information or time
information in the channel. This is not
an error. The text information may not
be displayed depending on the system
condition, for example, right after the
system has received a channel.
Precautions
Discs that this system CANNOT play
 Discs of non-standard shape (for example,
heart, square, star)
 Discs that have adhesive tape, paper, or
sticker attached to them
 Rental or used discs with attached seals
where the glue extends beyond the seal
 Discs that have labels printed using ink that
feels tacky when touched
Notes on discs
 Before playing, wipe the disc with a cleaning
cloth from the center out to the edge.
 Do not clean discs with solvents, such as
benzine thinner, or commercially available
cleaners or anti-static spray intended for
vinyl LPs.
 Do not expose discs to direct sunlight or heat
sources such as hot air ducts, nor leave it in a
car parked in direct sunlight.
 Do not use discs encircled with a protection
ring. This may cause a malfunction to the
system.
On operating voltage
Before operating the system, check that the
operating voltage of the unit is identical with
the voltage of your local power supply.
On safety
 The unit is not disconnected from the
AC power source (mains) as long as it is
connected to the wall socket, even if the unit
itself has been turned off.
 Completely disconnect the power cord
(mains lead) from the wall socket (mains)
if it is not going to be used for an extended
period of time. When unplugging the unit,
always grip the plug. Never pull the cord
itself.
 Should any solid object or liquid get into
the system, unplug the system, and have
it checked by qualified personnel before
operating it again.
 The AC power cord can be changed only by a
qualified service facility.
Continued
