Sealife DC100 - Manual (Page 26)

How to adjust the flash setting
The Flash settings can only be adjusted under RECORD mode. There are 4 settings
available: Auto, Red-Eye, Fill-In and Off. The default setting is AUTO for Land Mode and Sea Mode.
Flash is on while in External Flash Mode. To change the setting, press the Flash Mode button until the
desired one is selected.
The setting is conserved even if the camera power is off
Advanced Camera Operations
How to adjust the EV compensation
To adjust the EV compensation, perform the following:
1. Set the operating mode to RECORD.
2. Press the Menu button. The Record menu appears.
3. Select the EV COMPENSATION item using the arrow button ( ▲/▼), then press OK button.
4. Select the desired exposure value using the arrow button ( ▲/▼), then press OK button.
• The effective range is from -1.8 to +1.8 in steps of 0.3 EV.
• For more information on EV COMPENSATION, see page 22.
This setting is reset to 0.0 when the camera power is off.
Icon Mode Description
Auto
Red-Eye
Fill-In
Flash Off
Flash is enabled automatically in low light conditions
Auto Mode with Pre-Flash to reduce red eye effect
Flash is always enabled
Flash is always disabled
17
PIONEERmanREV 11/19/01 6:00 PM Page 17