Sealife DC100 - Manual (Page 49)

40
MUST DO for underwater housing:
1. Read these instructions before using the underwater housing.
2. Do not exceed the depth rating printed on the lens port of the housing.
3. Keep main O-Rings perfectly clean.
• Clean main O-rings with cleaning brush provided before every use. Do not remove O-rings. Do not
grease.
• Store camera and housing only after careful cleaning and when totally dry.
• Housing uses two large O-rings at housing sealing lid. Never use housing without both O-rings in place.
• If O-ring is damaged, contact the SeaLife Service Center. (See page 42)
• O-ring must be perfectly clean (no sand, dirt or debris) before sealing housing.
• Soak or rinse sealed housing with fresh water after drying.
4. Carefully close lid to seal housing.
• Make sure O-rings do not slip out of the groove when sealing.
• Press lid firmly and tightly down into housing to ensure a waterproof seal.
5. Never let any moisture or dirt get inside housing when opening.
• Only open and load the housing in dry cool air, such as inside an air-conditioned room.
6. For great underwater pictures you need:
• Clear water conditions, control your buoyancy before taking picture, get as close as possible to subject
(ideal distance is 2’ to 6’). Use the SeaLife Macro Lens/Filter for close-up pictures with super details
and vibrant colors.
7. Store housing at room temperature in a clean and dry place
• Do not expose housing to direct sunlight for prolonged periods of time.
• Do not store housing in hot locations, like the trunk of your car.
PIONEERmanREV 11/19/01 6:00 PM Page 40