Spectrum Brands Quad C6x VME64 - Manual (Page 65)

Spectrum Signal Processing Monaco Technical Reference
Registers
Part Number 500-00191 53
Revision 2.00
KIPL Enable Register
Address: 016D 8014h
D31.. ..D8
Reserved
D7.. ..D4 D3 D2 D1 D0
Reserved KIPL_END KIPL_ENC KIPL_ENB KIPL_ENA
The KIPL Enable Register is used to enable interrupts generated from the SCV64 to be
sent to a particular processor node. The /KIPL lines represent VME interrupts, location
monitor interrupt, SCV64 DMA, and SCV64 timer interrupts. These enable bits do not
affect the individual KBERR interrupt bits.
KIPL_END When set to “1”, interrupts to node D that are generated from the SCV64
/KIPL lines are enabled. Active high.
KIPL_ENC When set to “1”, interrupts to node C that are generated from the SCV64
/KIPL lines are enabled. Active high.
KIPL_ENB When set to “1”, interrupts to node B that are generated from the SCV64
/KIPL lines are enabled. Active high.
KIPL_ENA When set to “1”, interrupts to node A that are generated from the SCV64
/KIPL lines are enabled. Active high.
These bits are set to “0” upon reset.
Note: /KIPL interrupts must also be enabled by register writes to the SCV64.
Refer to the SCV64 data book for further information.