Seiko Instruments LTP F Series - Manual (Page 51)

4-1
CHAPTER 4
CONNECTING TERMINALS
Use the recommended connectors listed in Table 4-1 to connect the printer firmly to the external
circuits.
Table 4-1 Connectors for External Circuit and Recommended Connectors for the Other FFC
No. Function and Model
Number
Number of
Pins
Recommended Connectors
(External Circuit)
1 Thermal head control
connector
(JAE:IL-FPC-28CLIP) 28 Core number: 28,
Conductor type: 0.1
×0.8,
Strip length: 4.0,
Conductor pitch: P1.25
∗
2 Motor connector and
Detector connector
(MOLEX INC: 51021-0900) 9 MOLEX INC:
53047-0910 (straight type)
53048-0910 (right angle type)
51047-0910 (trunk type)
∗
For installing reinforcing plates, adjust the length of the reinforcing plate to conform with the layout in the mechanism
and the steel case.
Design the length between FFC terminals so that loads cannot be made after connecting to the PCB. This is because
the head unit can be slid back and forth by opening and closing the platen.