Seiko Instruments LTP F Series - Manual (Page 78)

9-4
9.1.2 Clearing a Paper Jam in the Autocutter
Owing to the paper jammed, if the cutter has been locked during paper cutting, power off the motor
immediately and cancel the lock by performing the following procedures manually.
(1) Tear transparent film from the upper surface of the autocutter (Figure 9-4 (1)), turn the knob
in the direction shown in Figure 9-4 (2) until the entire hole of the warm wheel can be seen
from the standby position confirmation window and retreat the movable blade. (Figure 9-4
(2))
Figure 9-4 Clearing a Paper Jam in the Autocutter
Open the platen after retreating the movable blade with the above way, and then clear a paper jam.
Transparent film
Knob Knob
Standby position confirmation window