H1000 pilot, Description/installation, Non-b&g paddle connection – B&G H1000 Autopilot User Manual
Page 44
h1000 pilot
description/installation
Page 43
non-B&G paddle connection
Any non-B&G speed sensor used with this system must have a speed signal output from a hall-effect
device giving positive pulses of 12V maximum.
1.
Locate the cable from the speed sensor to the instrument input.
2.
Cut cable (if necessary) and insert a junction box (B&G part no. 288-00-001). Connect like colour
to like colour.
3.
Use a length of 2-core screened cable (B&G part no. 135-0B-098 9m/30ft) to connect the speed
signal and ground of the paddle sensor to the speed input of the ACP computer unit.
4.
Calibrate the speed input in accordance with the instructions given in the Speed Calibration
section of the h1000 System User manual.
ACP Boat Speed
Terminals
Function
Cable
135-0B-098
Green
Speed signal input
Red wire
Red Not
used
Not
used
Black Ground
Blue
wire
Silver Screen Screen
Non B&G
Paddle Unit
Non B&G Display