B&G H1000 Autopilot - Manual (Page 6)

h1000 pilot
description/installation
Page 5
mounting procedure
panel mounting
Ensure that the display is installed on a flat surface, and there is sufficient room behind the panel to
accommodate the fixings and connections. Using the template supplied, cut a hole in the panel in the
desired position.
Fix the mounting bracket into the hole using the screws supplied.
Note: the sealing ring is fitted to the unit during manufacture, its purpose is to prevent moisture
penetration and reduce the effects of any vibration transmitted through the instrument panel.
Press the Pilot Display firmly into the mounting bracket; an audible ‘click’ will indicate that the case
is correctly located.
Secure the unit to the instrument panel by fitting the studs and thumbnuts supplied.
Caution: To avoid damaging the casing, fixing studs must only be tightened ‘finger-tight’.
Mounting
Bracket
Sealing Ring
(Fitted at Manufacture) Pilot Display
Unit
Protective
Cover