Sony STR-DN1000 - Manual (Page 42)

42 US
3
Press V/v repeatedly to select
“Auto Cal.”, then press or b.
4
Press V/v repeatedly to select
“Auto Cal. Start”, then press
or b.
5
Press to select “START”.
6
The measurement starts in five
seconds.
7
Measurement starts.
The measurement process will take
approximately 30 seconds with a test
tone. Wait until the measurement process
completes.
Tip
The measurements may not be performed correctly
or Auto Calibration cannot be performed when
special speakers, such as dipole speakers are used.
To cancel the measurement
The measurement will be canceled when you
do the following:
– Press ?/1.
– Press the input buttons on the remote or
press the INPUT SELECTOR +/–
repeatedly on the receiver.
– Press MUTING.
– Press SPEAKERS on the receiver.
– Change the volume level.
– Connect the headphones.
1
Confirm the measurement
result.
When the measurement ends, a beep
sounds.
2
Press V/v repeatedly to select
the item you want, then press
.
Count Down
Please press enter key
to stop.
5
Auto Calibration
RETURN
CANCEL
Auto Calibration
TONE T.S.P. WOOFER
Confirming/saving the
measurement results
Item Explanation
Retry Performs the Auto Calibration
again.
Save Saves the measurement
results and exits the setting
process.
Warning Displays warning concerning
the measurement results. See
“Message list after Auto
Calibration measurement”
(page 44).
Phase* Displays the phase of each
speaker (in phase/out of
phase).
Auto Calibration
Save