Sony STR-DN1000 - Manual (Page 53)

53 US
T
uner
Oper
at
ions
1
Press GUI MODE.
After “MENU ON” appears on the
display for a while, “GUI” appears and
the GUI menu appears on the TV screen.
Press MENU if the GUI menu does not
appear on the TV screen.
2
Press V/v repeatedly to select
“FM” or “AM”, then press or
b.
The FM or AM menu list appears on the
TV screen.
3
Press V/v repeatedly to select
“Auto Tuning”, then press
or b.
4
Press V/v.
Press V to scan from low to high, press v
to scan from high to low.
The receiver stops scanning whenever a
station is received.
In case of poor FM stereo
reception
1 Tune in the station you want to listen to
using Auto Tuning, Direct Tuning (page
53), or select the preset station you want
(page 54).
2 Press TOOLS/OPTIONS.
3 Press V/v repeatedly to select “FM Mode”,
then press or b.
4 Press V/v repeatedly to select “MONO”,
then press .
You can enter the frequency of a station
directly by using the numeric buttons.
1
Press GUI MODE.
After “MENU ON” appears on the
display for a while, “GUI” appears and
the GUI menu appears on the TV screen.
Press MENU if the GUI menu does not
appear on the TV screen.
2
Press V/v repeatedly to select
“FM” or “AM”, then press or
b.
3
Press V/v repeatedly to select
“Direct Tuning”, then press
or b.
4
Press SHIFT, then press
numeric buttons to enter the
frequency.
Example 1: FM 102.50 MHz
Select 1
b 0 b 2 b 5
Example 2: AM 1,350 kHz
Select 1
b 3 b 5
Tip
If you have tuned in an AM station, adjust
the direction of the AM loop antenna
(aerial) for optimum reception.
5
Press .
If you cannot tune in a station
“– – – .– – MHz” appears and then the screen
returns to the current frequency.
Make sure you have entered the right
frequency. If not, repeat step 4. If you still
cannot tune in a station, the frequency is not
used in your area.
Tuning into a station
automatically (Auto Tuning) Tuning into a station directly
(Direct Tuning)