Sony STR-DN1000 - Manual (Page 91)

91 US
A
m
p
lif
ie
r O
p
e
ra
tio
n
s
For details on the tuner function, see “Tuner
Operations” (page 52).
Tuning radio stations
1 Press TUNER repeatedly to select the
FM or AM band.
You can also use INPUT SELECTOR +/–
on the receiver.
2 Press TUNING + or TUNING –.
Press TUNING + to scan from low to high
frequencies, press TUNING – to scan from
high to low frequencies. The receiver stops
scanning whenever a station is received.
Selecting a frequency directly
(Direct Tuning)
1 After selecting the FM or AM band,
press D.TUNING.
2 Press SHIFT, then press numeric
buttons to enter the frequency.
3 Press .
1
Tune in the station that you
want to preset.
For details on the operation, see “Tuning
radio stations” (page 91).
2
Press SHIFT, then press ENT/
MEM.
“MEM” lights up for a few seconds.
Perform steps 3 and 4 before “MEM”
disappears.
3
Press PRESET + or PRESET –
to select a preset number.
30 FM and 30 AM preset numbers are
available. If “MEM” disappears before
you select the preset number, start again
from step 2.
4
Press ENT/MEM or b.
If SHIFT indicator is light off before you
press ENT/MEM, press SHIFT.
The station is stored as the selected preset
number.
If “MEM” disappears before you press
ENT/MEM, start again from step 2.
5
Repeat steps 1 to 4 to preset
another station.
Selecting a preset station
1 Press TUNER repeatedly to select the
FM or AM band.
2
Press PRESET + or PRESET –
repeatedly to select the preset station
you want.
You can also press SHIFT, then press
numeric buttons to select the preset station
you want. Then, press
to enter the
selection.
Listening to the FM/AM radio Presetting radio stations