Event setup – Samsung SVR-470 User Manual
Page 46
7.2. Event Setup
Scheduled Recording can be set up to 24 hours per day. Using the
buttons, move to an hour
block, and then press ENT to select a recording mode.
S : Sensor Recording
‐ : Recording Disabled
i g
C : Continuous (Normal) Record n
n Recording
M : Motion Detectio
T : Text Recording
Image Quality: Select High, Standard, or Low to adjust the image quality.
Recording Frames: Select the number of images (frames) that can be recorded per second. At
the 704x480 size, a maximum of 30 images can be selected, and a maximum of 120 images at
the 352x240 size.
Pre‐Event Recording: Select to start recording prior to an event. Selecting [Yes] commands the
DVR to start recording 3 seconds prior to an event, and [No] disables this option.
Post‐Event Recording Duration: Select a recording duration after an event; from 1 to 20
seconds.
Audio: Select "Yes" or "No" to record audio.
7.2. Event Setup
Set the event menus of a DVR such as Motion Detection, Sensor, and Alarm. Press the MENU button,
and then select a tab using the left and right buttons. The sub menus appear as shown in the picture
below. Press the ENTER button, and select a sub menu using the left and right buttons. Press ENTER
again, and then change the settings of the menu by pressing the left and right buttons.
7.2.1. Event Setup
① EVENT BEEP: Select ON or OFF to play a beep when an event occurs.
② EVENT AUTO SEQ: Select ON or OFF to display event screens in full screen mode.
45