Sharp Aquos LC-37D90U - Manual (Page 17)

16
22.
Air Air DIGITAL
22.1 22.1
Air
22
Air
2
Air
11
Cable
1
Cable
115
Cable ANALOG
5
Air
5
Air ANALOG
Simple button operations for
changing channels
You can change channels in several ways by pressing
AIR
or CABLE to select the antenna and then following
one of the methods below.
NOTE
• When selecting a 1-digit channel number, it is not
necessary to press 0 before the number.
• When you enter 0-9 only, channel selection will be made if
there is no operation within a few seconds.
To select a 3-digit channel number
(e. g., Channel 115):
Press 1 s1s5
To select a 4-digit channel number
(e. g., Channel 22.1):
Press 2 s2s • (DOT) s1sENT
NOTE
• When you enter 0–9 only, channel selection will be made if
there is no operation within a few seconds.
• If you push “0” by itself, nothing will happen.
• Complete the above steps within a few seconds.
• When you enter 0–9 and • (DOT), channel selection will be
made if there is no operation within a few seconds.
Method 1
Using CH r/s on the remote control unit or on the
TV.
Method 2
1 Press FLASHBACK to switch to the previously tuned
channel.
2 Press FLASHBACK again to switch back to the
currently tuned channel.
NOTE
• FLASHBACK will not work if no channel has been
changed after the TV is turned on.
Method 3
Using remote control buttons 0-9, • (DOT) to select
channels for VHF/UHF/CATV/DIGITAL.
To select a 1 or 2-digit channel number
(e. g., Channel 5):
Press 5 sENT
Watching TV