Dtvlink, Remote control pass-through, Osd switch – Sharp Aquos LC-37D90U User Manual

Page 44

Advertising
background image

43

Model

Input

PWR

OSD Switch

RC Pass-through

Start Remote Control Pass-through mode.

03

STB

NOTE

• Depending on the device connected, the On-Screen

Display of the connected i.LINK devices cannot be viewed
on the TV.

• You cannot view the On-Screen Display of the connected

device when the device is not connected with an i.LINK
cable.

• You cannot view the On-Screen Display of the connected

device when an analog signal is being received from the
connected device.

DTVLink

When the TV is connected to an i.LINK device such as
a digital STB/digital TV via the i.LINK cable, you can
view the On-Screen Display of the connected i.LINK
devices on the TV if the device supports this function.
DTVLink also allows you to control the connected
i.LINK devices using the TV's remote control without
displaying the i.LINK control panel.

Press i.LINK to display the i.LINK control
panel.

1

Press

c/d to select “RC Pass-through”, and

then press ENTER.

• The message appears and the TV enters the RC

Pass-through mode.

• “RC Pass-through” will be displayed on the TV

screen for a few seconds when a designated
button for controlling the i.LINK device is
pressed.

2

OSD Switch

You can view the On-Screen Display of the connected
i.LINK devices on the TV.

Press

c/d to select “OSD Switch”, and then

press ENTER to turn “OSD Switch” on or off.

• The “OSD Switch” status indicator turns green

when the “OSD Switch” is on.

• The “OSD Switch” status indicator turns red

when the “OSD Switch” is off.

2

Using external equipment

Remote Control Pass-through

You can control the connected i.LINK devices using
the TV's remote control without displaying the i.LINK
control panel.

• The remote control buttons that can be used with

Remote Control Pass-through during the “Pass-
through” mode are shown below.

NOTE

• To cancel RC Pass-through, press i.LINK on the remote

control.

• Depending on the device connected, RC Pass-through

cannot be used.

Press i.LINK to display the i.LINK control
panel.

1

The “OSD Switch” status indicator

Advertising