Sharp Aquos LC-37D90U - Manual (Page 35)

34
Setting the input source (i.LINK)
If you want to receive an analog signal from the i.LINK device, you need to also use INPUT 1, INPUT 2, INPUT 3,
INPUT 4 or INPUT 5 to connect the i.LINK device to the TV and follow the steps below to designate the INPUT you
are using.
Example: a Digital STB/Digital TV connected to the TV using i.LINK terminal and INPUT 2
Press c/d to select “Digital Setup”.
Press a/b to select “i.LINK Setup”, and
then press ENTER.
Press a/b to select “Input Select”, and then
press ENTER.
Press MENU and the MENU screen displays.
Using external equipment
1
2
4
3
Press a/b to select the input source.
5
Press MENU to exit.
6
i.LINK Autoswitch
Input Select
Standby Mode
Recording Mode
INPUT 1
INPUT 2
INPUT 3
INPUT 4
INPUT 5
i.LINK cable
(commercially available)
Digital TV STB
(Example)
AV cable
(commercially available)