Woodstock SHOP FOX W1740 - Manual (Page 28)

-26-
Model W1740 (For Machines Mfg. Since 1/13)
SE
RV
IC
E
When replacing a V-belt, align pulleys if required.
To.check.and.align.the.pulleys,.do.these.steps:
1.. DISCONNECT SANDER FROM POWER!
2. Remove the side panel, and loosen the four bolts
that secure the motor to the motor mounting plate.
3. Slide the motor as needed to align the pulleys to the
straightedge shown in Figure 21.
Note: You can also loosen the set screws on the
motor pulley to fine tune any pulley adjustments.
4. When the pulleys are aligned, tighten the four
motor mount bolts.
5. Tension the V-belt (refer to Tensioning on Page.25)
and replace the belt cover.
Pulley.Alignment
Figure.21. Pulley alignment.
( Note: All panels removed for clarity.)