Woodstock SHOP FOX W1740 - Manual (Page 34)

-32-
Model W1740 (For Machines Mfg. Since 1/13)
SE
RV
IC
E
For this adjustment, you will adjust the dust scoop up
or down to focus dust collection suction where the most
dust is created (see Figure.33).
To.adjust.the.dust.scoop.gap,.do.these.steps:
1.. DISCONNECT SANDER FROM POWER!
2. Open the top cover.
3. Insert two gauge boards under the sanding drum and
dust scoop (see Figure.34).
4. Raise the table until the drum just touches the
gauge blocks.
5. Loosen the dust scoop mounting bolts (see Figure.
35) and slide the scoop up or down until it is 1 ⁄
32
"
above the gauge blocks (see Figure.33). You may
have to bend the lip of the dust scoop to get the
appropriate gap.
6. Tighten the dust scoop mounting bolts.
7. Close the top cover and secure it shut.
Dust.Scoop.Gap
32"
1
Gauge Board
Conveyor Table
Dust Scoop
Figure.33. Dust scoop gap.
Figure.34. Gauge boards in position.
Figure.35. Dust scoop.
Hex Bolts
Dust Scoop