Woodstock SHOP FOX W1740 - Manual (Page 32)

-30-
Model W1740 (For Machines Mfg. Since 1/13)
SE
RV
IC
E
9. Loosen the lock nuts (see Figure.29) on the pillow
block bearing that requires adjustment.
10. Rotate the four set screws 1 ⁄
8
of a turn clockwise to
raise the pillow block bearing.
Note: Turn all set screw sets an equal amount.
11. Tighten the lock nuts and recheck the alignment,
using the gauge boards and repeating Steps.1–8 from
the previous subsection. Tightening the lock nuts will
pull the drum downward slightly. Be sure to adjust to
compensate for this movement. Do.not.over.tighten.
the.lock.nuts..The.pillow.block.bearings.can.break.
if.over.tightened. Figure.29. Pillow bearing housing.
Locknut Set Screw