Woodstock SHOP FOX W1740 - Manual (Page 33)

-31-
Model W1740 (For Machines Mfg. Since 1/13)
SE
RV
IC
E
If the drum-to-conveyor tracking (see Figure.30) is off
track by more than 1 ⁄
8
", you will have to adjust the track-
ing.
To.check.and.adjust.the.drum-to-conveyor.tracking,.do.
these.steps:
1. DISCONNECT SANDER FROM POWER!
2. First measure the distance between the outside
of the drum and the inside of the dust scoop (see
Figure.31). The distances should be within 1 ⁄
8
" of
each other at each end of the drum.
3. If the measurements are not within 1 ⁄
8
", the drum
can be moved by loosening the lock nuts on the pil-
low block bearings (see Figure.32) and moving one
end of the drum forward or backward as necessary in
the slotted holes.
. Note: After you have adjusted the drum, tighten
the lock nuts and recheck the alignment by repeat-
ing Steps.1–3.
Drum-to-Conveyor.
Tracking
Figure.31. Measuring drum alignment.
Figure.32. Pillow bearing housing.
Non Tracking Drum
Center-Tracking Conveyor
Figure.30. A non-tracking drum.
Locknut Set screw