Sony CMT-CP505MD - Manual (Page 20)

20 GB
CMT-CP505MD 4-241-515-11(1) GB
7
To record using the Group Function,
perform the following procedure
depending on where you want to
record:
To record into a new group
Press GROUP SKIP repeatedly until “New
Group” appears.
To record into an existing group
Press GROUP SKIP repeatedly until the
desired group appears.
Proceed to step 8 to record not using the
Group Function.
8
Press ENTER/START while “Press
START” flashes.
Recording starts.
When the recording is completed, the CD
player and the MD deck stop automatically.
To stop recording
Press MD x.
Recording a CD on an MD and a tape
at the same time
Load a recordable tape, then select “DUAL
SYNC” in step 5.
Even if the MD or the tape ends part-way
through the recording, the other continues
recording.
To record only your favorite CD
tracks
You can record only your favorite CD tracks
using the Program Play. Between steps 2 and 3,
perform steps 1 to 5 of “Programming CD
tracks” (page 10).
Tips
• For details about LP2/LP4 recording, see page 26.
• For details about High-Speed CD-MD Synchro
Recording, see page 27.
Notes
• You cannot pause the recording.
• If the play mode is set to the Repeat Play or Shuffle
Play, the play mode switches to Normal Play in step
6.
no indication
(stereo)
LP2
(LP2 stereo)
LP4
(LP4 stereo)
MONO
(monaural)
Recording a CD on an MD
— CD-MD Synchro Recording/High-
Speed CD-MD Synchro Recording
You can record a whole CD on an MD. In
addition to normal-speed recording, you can
also record at high speed (approximately four
times the normal speed).
You can select the recording time by switching
the recording mode.
1
Load a recordable MD.
2
Load a CD you want to record.
3
To record using the Group Function,
press GROUP ON/OFF repeatedly until
GROUP indicator lights up.
To record not using the Group Function,
turn off the GROUP indicator and proceed
to step 4.
4
Press REC MODE repeatedly to select
the recording mode.
Select the desired recording time.
Recording time Select
(Recording mode)
Standard
Double
Quadruple
Double
(change the stereo
signal to monaural)
5
Press SYNCHRO repeatedly until
“CD
tMD SYNC” appears.
To record at high speed (High-Speed CD-
MD Synchro Recording), select “HISPEED
SYNC”.
6
Press ENTER/START.
“Press START” flashes.
The MD deck stands by for recording and
the CD player pauses for playback.