Sony CMT-CP505MD - Manual (Page 24)

24 GB
CMT-CP505MD 4-241-515-11(1) GB
Recording tips (continued)
Marking track numbers
automatically during recording
— Level-Synchro Recording
The Level Synchro Recording Function is
factory set to on, so the track numbers are
automatically marked. If “L-SYNC” does not
appear during recording, turn on the Level
Synchro Recording as follows. Track numbers
are automatically marked when the input signal
is continuously below a certain level for more
than two seconds and then exceeds that level.
1 Press MD on the remote.
2 Press MENU/NO on the remote.
3 Press . or > on the remote
repeatedly until “Setup?” appears, then
press ENTER/YES on the remote.
4 Press . or > on the remote
repeatedly until “T.Mark Off” (or “T.Mark
LSync”) appears, then press ENTER/YES
on the remote.
5 Press . or > on the remote
repeatedly to select the setting, then press
ENTER/YES on the remote.
To
Turn on the Level
Synchro Recording
Function
Turn off the Level
Synchro Recording
Function
When you set the Level Synchro Recording
Function on, “L-SYNC” lights up.
6 Press MENU/NO on the remote.
To continue recording, follow the procedures
described for each type of recording.
Select
T.Mark LSync
(factory setting)
T.Mark Off
To change the trigger level for Level
Synchro Recording
When the Level Synchro recording is set to
“On”, track numbers are automatically marked
when the input signal is below the trigger level
set in this section for more than two seconds
and then exceeds that level. The factory setting
is “–50 dB”.
When the recording source is tape or radio
program and the track numbers are not marked
properly because of noise, set this level higher
so that track numbers are marked easily.
Perform the following procedure to change the
signal level that triggers Level Synchro
Recording.
1 Press MD on the remote.
2 Press MENU/NO on the remote.
3 Press . or > on the remote
repeatedly until “Setup?” appears, then
press ENTER/YES on the remote.
4 Press . or > on the remote
repeatedly until “LS(T)” appears, then
press ENTER/YES on the remote.
5 Press . or > on the remote
repeatedly to select the level, then press
ENTER/YES on the remote.
You can set the level at any value between
–72 dB and 0 dB, in 2 dB steps.
6 Press MENU/NO on the remote.
Marking track numbers at a specific
point during recording
— Track Mark
You can mark track numbers at any time during
manual recording, regardless of the type of
source sound.
Press MD zREC during manual recording
at the point you want to add a track mark.
The tracks following the added one are
renumbered.
Marking track numbers after
recording
Use the Divide Function (page 36).