Sony CMT-CP505MD - Manual (Page 28)

28 GB
CMT-CP505MD 4-241-515-11(1) GB
Before you start editing
You can edit an MD only when:
• The MD is recordable.
• The MD play mode is normal play.
Check the following, before editing.
1
Check the tab of the MD to be edited.
Slide the tab to close the slot.
If the MD is protected, you cannot edit the
MD.
2
Press PLAY MODE repeatedly until
both “SHUF” and “PGM” disappear.
You can edit the MD only in normal play
mode. You cannot edit the MD in Shuffle or
Program Play mode.
To quit while editing
Press MENU/NO on the remote.
After editing
Press MD Z to remove the MD or press
?/1 (power) to turn off the system.
“TOC” or “STANDBY” starts flashing. The
TOC is updated and editing is completed.
Before pulling out the mains lead
MD editing is completed when the MD Table
of Contents (TOC) is updated. The TOC is
updated when you eject the MD or press ?/1
to turn off the system. Do not pull out the
mains lead before updating the TOC or while
updating the TOC (while “TOC” lights up or
flashes) to ensure a complete editing.
Labelling an MD
— Name Function
You can create titles for your recorded MDs,
tracks, and groups as follows.
During recording
During the CD-MD Synchro Recording, CD-
TEXT information is recorded automatically.
To cancel recording the CD-TEXT information
automatically, change the setting as follows.
Use the remote for the operation.
After pressing MD to switch the function to
MD, press MENU/NO, press . or >
repeatedly until “Setup?” appears, then press
ENTER/YES. Press . or > repeatedly
until “Txt Save On” appears, then press
ENTER/YES. Again, press . or >
repeatedly until “Txt Save Off” appears, then
press ENTER/YES, then press MENU/NO.
The factory setting is “ON”.
Note
Even when “Txt Save Off” is selected, the CD-TEXT
information is recorded automatically depending on
the disc.
After recording
Use Name Function. You can input a total of
approximately 1,700 characters for the disc
title, track titles and group titles on a single
MD.
When labelling an MD recorded using
the Group Function, be sure to label the
disc with the Group Function on so as
not to rewrite the group management
information by mistake.
For details on the group management
information, see page 18.
MD – Editing