Installation, Uninstalling the device – Silvercrest KH 2377 User Manual
Page 16
14
Installation
KH 2377
GB
IE
If necessary secure your device against theft with additional measures.
Attach the securing screw with the anchoring plate
70
and the securing
material to the engine fi rewall of the vehicle.
Carefully push the device into the mounting duct until it locks into place.
After all connections have been made activate the
RESET button with a ball
point pen or other pointed object.
Attach the face plate as described under "Installing the face plate".
IMPORTANT
Possible damage to the cable!
Observe the position of the cable when sliding the device into the duct so
►
as to avoid damaging it.
Finally put on the bezel frame.
Uninstalling the device
To remove the installed device proceed as follows:
Remove the bezel frame
67
.
Insert the right and left keys
69
into their respective slots on the sides of the
device. (The tabs are now bent back.)
Pull the device out.