Silvercrest KH 2377 - Manual (Page 18)

16
Handling and operation
KH 2377
GB
IE
Remote control
Inserting the battery
NOTICE
The supplied battery (Type CR2025) is already installed in the remote ►
control when delivered. Before use remove the isolation strip from the
battery compartment.
For replacement with a new battery procede as follows:
Pull the battery compartment out of the remote ‹
control by pressing the lateral locking device and
at the same time pull the battery compartment out.
Remove the depleted battery and insert a new ‹
battery of the type CR2025 (Button cell) into the
battery compartment. Be sure to insert the battery
with the correct polarity.
Slide the battery compartment back into the remote ‹
control until it locks into place.
Using the remote control
Point the remote control to the Infrared sensor ‹ 4 on the front panel of the
device.
NOTICE
You can use the remote control up to a distance of 8 m from the device. ►
Handling and operation
In this chapter you receive important information for the handling and operation
of the device.
NOTICE
Most of the functions can be operated by the buttons on the device as well ►
as by the buttons on the remote control. In these instructions operation via
the buttons on the device is described. Any reference to the push buttons
on the remote control will be specifi cally highlighted.
If no setting is made and/or no button pushed within approx. 5 seconds the ►
device returns to its previous operating mode. Changed settings are saved.