Silvercrest KH 2377 - Manual (Page 23)

21
Handling and operation
KH 2377
GB
IE
Radio functions
Select frequency range
Press the ‹ BAND/ENT button to switch between VHF (F1, F2, F3) and
medium wave (M1, M2).
Automatic station search
Press briefl y the buttons I◂◂ or ▸▸I to start a station search. The search will ‹
stop when a station is found.
Manual station selection
Hold down one of the buttons I◂◂ or ▸▸I for two seconds, in the display ‹
appears MANUAL.
Now press the buttons I◂◂ or ▸▸I to change the frequency in steps of ‹
0.05 MHz (VHF) and/or 9 kHz (MW) until the desired frequency is set.
If no button is pressed for approx. two seconds the automatic station search is set
again. AUTO appears in the display.
Saving radio stations
For each frequency range 6 stations can be saved.
Hold down for approx. 3 seconds one of the station buttons ‹ 1 to 6 to save
the currently set station. The successful saving is signalised by the showing
of the numbers 1 to 6 in the display.
Search for stations with alternative frequencies
Press the ‹ SCAN/REC button to search for stations with an AF signal in the
VHF band range.
The search stops with each found station for 5 seconds and then continues
searching.
If you want to listen to and save the station press the ‹ SCAN/REC button to
stop the search.
Hold down for approx. 3 seconds one of the station buttons ‹ 1 to 6 to save
the currently set station. The successful saving is signalised by the showing
of the numbers 1-6 in the display.
Accessing saved stations
Select with ‹ BAND/ENT the frequency range.
Press one of the station buttons ‹ 1 to 6, to access the saved station.