Symbol Technologies Spectrum24 AP-4131 - Manual (Page 50)

Configuring the AP
40 AP-4131 Access Point Product Reference Guide
5. Press ESC to refresh the display. The AP displays the Main Menu.
Symbol Access Point
MAIN MENU
Show System Summary AP Installation
Show Interface Statistics Special Functions
Show Forwarding Counts Set System Configuration
Show Mobile Units Set RF Configuration
Show Known APs Set Access Control List
Show Ethernet Statistics Set Address Filtering
Show RF Statistics Set Type Filtering
Show Misc. Statistics Set SNMP Configuration
Show Event History Set Event Logging Configuration
Enter Admin Mode
6. Refer to section 2.12.2: ”Updating Using Xmodem” on page 132 to
update the AP firmware or HTML file or to section 2.2: ”Navigating the
UI” on page 48.
7. Exit the communication program to terminate the session.
2.1.3 Using a Dial-Up Connection
A dial-up connection requires a straight-through cable between the modem
and the AP. The remote PC requires a modem and a communication
program (Microsoft Windows Terminal program).
See Appendix B for information on the modems supported by the AP.
1. Set
Modem Connected
to
Yes
in the System Configuration screen.
2. Attach a straight-through serial cable from the AP to the modem.
3. Verify the modem connects to the telephone line and has power.
Refer to the modem documentation for information on verifying
device power.
4. From the remote terminal, start the communication program.