Silvercrest CDV-710 - Manual (Page 18)

18
Deutsch
English
A5 (blue):
+12V: switching voltage output (max. 0.5 A). When the device is turned on, the
switching voltage adjoins contact A5 and serves to retract or extract an automatic antenna and
as operational voltage for antenna amplifiers.
A7 (red):
Connection for +12V trigger voltage. Connect to terminal # 15 of the vehicle.
If contacts A4 and A7 are switched, the device will “forget” the stored stations after the ignition
is turned off.
A8 (black): Attach the connection for the ground (diameter at least 2.5 mm) to terminal # 31
(ground) of the vehicle.
Note:
Depending on the manufacturer, the contacts on your vehicle connection may be assigned
differently. This is not a defect of the device but caused by a deviating connector pin
assignment by the manufacturer of your vehicle. To provide a connection that conforms to this
device, please purchase an appropriate adapter cable from a specialised dealer if required.
Please consult a specialist in your area if you have any questions about the connections.
8.4 Speakers
Cable adapter ISO plug B Front speakers Back speakers
B3: right + grey B1: right + violet
B4: right - grey/black B2: right - violet/black
B5: left + white B7: left + green
Maximum output for 4-8 Ω speakers:
4 x 20W Music output
B6: left - white/black B8: left - green/black
Caution:
Don’t attach the speaker connections to each other electrically and don’t connect them to
ground! This can lead to the destruction of the device. Please pay attention to illustr. 8.5 – 8.7.