Silvercrest CDV-710 User Manual
Page 37
37
Deutsch
English
Note:
After selecting a range, the station last selected in this range will be heard.
When the monitor is open, the “BAND” button
on the screen is also available for the
selection of the wavelength range.
14.3 Searching for a radio station with the scanner
To set the stations, select the desired wave band with the “BAND” button (section 13.2). In
order to begin searching in the desired direction, briefly press the five-way multifunction button
. Press the button towards the left to diminish the search frequency or to the right to increase
the search frequency. The scanner will stop at the next available station.
When the monitor is open, the buttons and on the on-screen keyboard are also available
to change the frequency.
14.4 Manual search for a radio station
In order to select a station manually, press the five-way multifunction button for about three
seconds towards the right or left. The display will indicate “MANUAL”. Now press the five-way
multifunction button towards the right to increase the frequency, or to the left to diminish the
frequency until the desired frequency is indicated on the display. The frequency will change in
50kHz increments in the FM range. If there is no entry for about seven seconds, the device will
switch back to automatic station search. The display will indicate “AUTO”.
When the monitor is open, the buttons and on the on-screen keyboard are also available
to change the frequency. Here you also have the option to search manually, by pressing one of
the buttons and for three seconds. MANUAL will be indicated in the corresponding field. If
there is no entry for about seven seconds, the device will switch back to automatic station
search. The corresponding field on the screen will indicate “AUTO” again.