Silvercrest CDV-710 - Manual (Page 71)

71
Deutsch
English
24.3 Changing the battery
Remote control
To change the battery, the battery compartment can be pulled out towards the front.
Now replace the old battery with a new one of the same type (CR 2025). Please pay attention to
the polarity ("+ pole" to the top) when you insert the battery. Please only touch the battery on
the edge, since there might be contact problems otherwise.
Now slide the battery compartment with the new battery back into the case. Make sure that the
battery compartment is positioned flush inside the case again after changing the battery.
Remote control (DUAL ZONE)
To change the battery, please press the lock on the left side of the
battery case slightly to the right. Now the battery compartment can
be pulled out towards the front.
Now replace the old battery with a new one of the same type (CR
2025). Please pay attention to the polarity ("+ pole" to the top) when
you insert the battery. Please only touch the battery on the edge,
since there might be contact problems otherwise.
Now slide the battery compartment with the new battery back into
the case. Make sure that the battery compartment snaps back into
the case.
Note:
Please remove the safety disk on the battery compartment before first using the remote
control. Otherwise the remote control won’t operate properly.