Sony DSR-85 - Manual (Page 35)

Chapter 3 Convenient Functions for Editing Operation
Chapter 3 Convenient Functions for Editing Operation
35
Rerecording the Time Code — TC
Insert Function
The TC insert function makes it possible to use the
internal time code generator to rewrite time code and
user bits when the time code recorded on a tape is
discontinuous.
You can start recording time code from an initial value
which can be set freely. (See page 33.)
Notes
• Use a tape which is recorded in the DVCAM format.
(You cannot use the TC insert function with a tape
recorded in DV format.)
• The time code recording starts from the tape position
at which this unit was servo-locked. (From the
current tape position, there is about 3 seconds delay
at playback of normal speed or about 16 seconds
delay at playback of 4 times normal speed.) To start
time code recording at the current tape position, first
rewind the tape by the time needed to allow the unit
to be servo-locked before reaching the current tape
position.
• If you use a tape on which ClipLink log data is
recorded, the ClipLink log data will be lost.
1
Press the MENU button on the menu control panel.
Setup menu SYSTEM MENU
SETUP MENU
AUTO FUNCTION
HOURS METER
2
Press the ≥ button to select “AUTO FUNCTION”.
Auto func SYSTEM MENU
SETUP MENU
AUTO FUNCTION
HOURS METER
3
Press the ÷ button.
This displays the items in the level 1 of the auto
mode execution menu.
QSDI DUB AUTO FUNCTION MENU
QSDI DUBBING
TC INSERT
4
Press the ≥ button to select “TC INSERT”.
TC insert AUTO FUNCTION MENU
QSDI DUBBING
TC INSERT
Monitor screen
Time counter display
Monitor screen
Time counter display
Monitor screen
Time counter display
Monitor screen
Time counter display
(Continued)
6,8,9
3,5
2,4
1
6 SYNC PHASE SC PHASE MENU
MONITOR SELECT
RESET(NO)
SET(YES)
CH-
1/2
CH-
3/4
CH-
1/3
CH-
2/4
MIX
TC PRESET