Sony 4-130-033-13(1) - Manual (Page 35)

35 US
A
m
p
lif
ie
r O
p
e
ra
tio
n
s
a)
For details, refer to the page in the parentheses.
b)
“CONTROL FOR HDMI” scroll across the display, then “CONTROL” appears.
c)
The initial setting for the model of area code MX is “CTRL ON”.
d)
This parameter is only available after the when the result of the Auto Calibration is saved.
e)
When the Auto Calibration result is saved, you can adjust the setting in 0.01 meter (1 inch) increment.
f)
This parameter is only available when SAT input is selected.
g)
This parameter is only available if the S-AIR transmitter (not supplied) is inserted to the EZW-T100 slot on
the receiver.
h)
This parameter is only available when using the EZW-T100A wireless transceiver (for model of area code UC
only).
Menu
[Display]
Parameters
[Display]
Settings Initial setting
S-AIR settings
[S-AIR]
(page 40)
S-AIR ID
g)
[S-AIR ID]
ID A, ID B, ID C ID A
PAIRING
g)
[PAIRING]
START, CONDIN START
S-AIR mode
g)
[MODE]
PARTY, SEPARATE PARTY
RF Change
g)
[RF CHNG]
RF AUTO, RF ON, RF OFF RF AUTO
RF Power
g)h)
[RF POWER]
PWR HIGH, PWR LOW PWR HIGH
S-AIR standby
g)
[STBY]
STBY ON, STBY OFF STBY OFF