Sony 5500 - Manual (Page 158)

158
Menu List
App
endi
x
Items Relating to the Video Control (Nos. 706 to ...)
628 REMAIN TIME
DISPLAY [off]
10min
on Sets whether to display remaining time on the tape in
superimposed character position.
off: Do not display remaining time.
10min: Display remaining time when it is 10 minutes or
less.
on: Always display remaining time.
Note
The remaining time on the tape is not displayed when no
cassette is inserted. The remaining time is not also
displayed until the VTR finishes detecting the diameter of
the wound tape and estimating the remaining time
immediately after the cassette is inserted.
630 TC CONVERT [off]
on Selects whether to convert the playback time code to the
operating frequency time code when tapes recorded with
different frame rates are used for off-speed playback.
off: Does not convert the time code.
on: Converts the time code.
631 ORIGINAL TC
display [off]
on When item 630 is set to “on,” this setting specifies whether
the 24-frame time code is displayed or not on the control
panel of the VTR before conversion.
off: The 24-frame time code is not displayed before
conversion.
on: The 24-frame time code is displayed before conversion.
The type of time code displayed is specified by item
603.
632 JUMPING TC
select
–2H
–1H
+1H
+2H
+3H
0H
Sets the loopback point (JUMPING TC) for converting time
code with respect to the reference time code (STARTING
TC) for conversion.
–3H: The JUMPING TC is set 3 hours before STARTING
TC.
–2H: The JUMPING TC is set 2 hours before STARTING
TC.
–1H: The JUMPING TC is set 1 hour before STARTING TC.
+1H: The JUMPING TC is set 1 hour after STARTING TC.
+2H: The JUMPING TC is set 2 hours after STARTING TC.
+3H: The JUMPING TC is set 3 hours after STARTING TC.
0H: The JUMPING TC is set 1 frame before STARTING TC.
Item number Item Setting Function
706 FORCED
VERTICAL
INTERPOLATION
OFF [auto]
forced YADD off Specifies whether or not Y-add operation mode is
automatically turned on during DT playback.
auto: Y-add operation mode is automatically turned on.
forced YADD off: Y-add operation mode is off all the time.
707 ROUNDING
(SRW-5500 only) [simple]
adaptive
Selects whether to perform A-ROUNDING
TM 1)
processing.
simple: Do not perform A-ROUNDING
TM
processing. 10-bit
input signals are simply rounded to 8 bits.
adaptive: Perform A-ROUNDING
TM
processing. 10-bit
input signals are adaptively rounded to 8 bits.
Item number Item Setting Function
[ 3H] −
1) A-ROUNDING™
A method for rounding a 10 bit signal to 8 bits. This process suppresses
step noise that occurs when lines which differ slightly from the horizontal
are displayed.
A-ROUNDING is a trademark of Sony Corporation.