Sherwood R-671 - Manual (Page 20)

19
SETTING THE SPEAKER SETUP MANUALLY
• Press the POWER switch to enter the standby mode and then turn the power on.
Before setting the speaker setup
Note: When the SPEAKER button is set to off or the EXTERNAL IN is selected as an input source, the speaker setup
procedure cannot be performed.
When selecting each setting mode, When adjusting the selected mode
to the desired setting,
2 1
• Each time the ADJUST UP( / ) or DOWN( / )
button is pressed, one of the settings is selected
and displayed for several seconds as follows.
Y(es) N(one)
• When the subwoofer is set to “N”, the front speaker
is automatically set to “L”.
• You can select one of 2 different speaker settings.
L S
(L: Large, S: Small)
• You can select one of 3 different speaker settings.
(L: Large, S: Small, N: None)
• You can select one of 3 different speaker settings.
• You can select one of 3 different speaker settings.
• Each time the SPEAKER SETUP button is
pressed, the speaker setting mode changes in
succession and is displayed for several seconds
as follows.
• When the speaker setting mode disappears, press
the SPEAKER SETUP button repeatedly to select
the desired mode.
• When selecting the subwoofer,
“SUB-W Y”
• When selecting the front speaker size,
“FRONT L”
• When selecting the center speaker size,
“CENTER L”
• When selecting the surround speaker size,
“SURR L ”
• When selecting the surround back speaker size,
“SURR-B L”