Sherwood R-671 - Manual (Page 42)

41
Press the CURSOR UP( )/DOWN( )
buttons to select the AUTO SPEAKER
SETUP, then press the ENTER button.
1
Press the CURSOR UP( )/DOWN( )/
LEFT( )/RIGHT( ) buttons to specify
the setting condition according to the
number of speakers installed and
speakers’ frequency characteristics.
2
• After you have installed this receiver and connected all the components, you should adjust the speaker settings for the
optimum sound acoustics according to your environment and speaker layout.
• Even when you change speakers, speaker positions, or the layout of your listening environment, you should adjust the
speaker settings, too.
Note:
• Because the microphone for Auto Speaker Setup is designed for use
with this receiver, to use the auto speaker setup function, do not use a
microphone other than the one supplied with this receiver.
SETTING THE SPEAKER SETUP
When selecting the AUTO SPEAKER SETUP
• Auto Speaker Setup lets you avoid troublesome listening-based speaker setup and achieve good surround sound.
You should connect the supplied microphone to the SETUP MIC jack so that this receiver can analyze the
information from a series of test tones emitted from speakers and can adjust the size, distance and sound level of
each speaker automatically.
• If you want to personalize your speaker setup and channel level setup by making the settings manually, perform
the “When selecting the MANUAL SPEAKER SETUP” procedure on page 42, “Adjusting each channel level with
test tone” procedure on page 31 and “Adjusting the current channel level”on page 32.
• To specify the layout of the installed speakers, press
the CURSOR UP( ) or DOWN( ) button.
• To specify the crossover frequency, press the
CURSOR LEFT( ) button.
You can specify the crossover frequency with the
range of 40~130 Hz in 10 Hz intervals.
• To specify the subwoofer, press the CURSOR
RIGHT( ) button.
Preparations
1. Connect the supplied microphone to the SETUP MIC
jack on the rear panel,(For details, refer to
“CONNECTING MICROPHONE” on page 9)
2. Place the microphone on a flat level surface at your
normal listening position.
• If possible, use a tripod, etc. to attach the microphone
at the same height as your ears would be when you
are seated in your listening position.
• Ensure there are no obstacles between the speakers
and the microphone.