Sherwood R-671 - Manual (Page 25)

24
LISTENING TO A PROGRAM SOURCE
Operations
Before operation
Select the desired input source.
3
• Enter the standby mode.
• The STANDBY indicator lights up.
When the power operation switch
is in the OFF or STANDBY state,
the apparatus is still connected on
some AC line voltages.
Please be sure to unplug the cord when
you leave home for, say, a vacation.
• To switch the power off, push the POWER switch
again.
• Then the power is cut off and the STANDBY
indicator goes off.
• Then the SPEAKER indicator lights up and the
sound can be heard from the speakers connected
to the speaker terminals.
• When using the headphone for private listening,
press the SPEAKER button again to switch the
speakers off.
When selecting the EXTERNAL IN as desired,
• “EXT IN” is displayed and the 7 or 6 separate
analog signals from the component connected to
this input can be controlled only by channel
level(s) and volume depending on the surround
back speaker setting.
• Press the EXTERNAL IN button or select the
desired input source to cancel the external in
function.
• These analog signals can be heard only, not
recorded.
Switch the speakers on.
2
• Note : Before operating this receiver with the supplied remote control, refer to “Universal Remote Controls” on
page 12 for details about operation.
• In the operating mode, if the STANDBY button on
the remote control is pressed, the receiver is
turned off and enters the standby mode.
• In the standby mode, if the INPUT SELECTOR
button on the remote control is pressed, the
receiver is turned on automatically and the
desired input is selected.
In the standby mode, turn the power
on.
1
• Each time the “AUDIO” button on the front panel
is pressed, the input source changes as follows;
• Each time the “VIDEO” button on the front panel
is pressed, the input source changes as follows;