Sherwood R-671 - Manual (Page 32)

31
• If the parameter display disappears, start from
the step again.
At the desired parameter, adjust it as
desired.
2
Repeat the above steps and to
adjust other parameters.
3
• When selecting the Dolby Virtual Speaker Reference mode(“DOLBY (D) VS REF”) or the Dolby Virtual
Speaker Wide mode(“DOLBY (D) VS WIDE”), you can select the desired one of different speaker layouts
for actual speakers to be used.
• Press the PARAMETER button to select the desired speaker layout.
• Each time this button is pressed, the speaker layout mode
changes depending on the selected Dolby Virtual Speaker
mode as follows:
* In case of Dolby Virtual Speaker Reference mode,
* In case of Dolby Virtual Speaker Wide mode,
Selecting the desired speaker layout for Dolby Virtual Speaker mode
Enter the test tone mode.
1
• The volume level of each channel can be adjusted easily with the test tone function.
Note : When the EXTERNAL IN is selected as an input source, the SPEAKER button is set to off or it
is in the stereo mode, the test tone function does not work.
Adjusting each channel level with test tone
• The test tone will be heard from the speaker of each
channel for 2 seconds as follows:
Note : When the speakers are set to “None”, the corresponding speaker layout modes cannot be
selected.
• When the speaker setting is “N”, the test tone of the
corresponding channel is not available.