Shiro ADSL 2/2+ Ethernet Modem - Manual (Page 85)

User Manual
Page 85 of 92
Diagnostics
Diagnostic Test is used for investigating whether the router is properly connected to the WAN Network.
This test may take a few seconds to complete. To perform the test, select your connection from the list
and click Test. Before running this test, make sure you have a valid DSL link.
Diagnostics
To run diagnostic test:
1. From the Advanced Menu, select Diagnostics. This opens the Diagnostics page.
2. Click Test. The test status will appear after running the diagnostic test. If a test failed, click
Help to get the solution.
Ping Test
Once you have your router configured, it is a good idea to make sure you can ping the network. If you
can ping an IP on the WAN side successfully, you should be able to surf the Internet.
To perform a ping test:
1. From the Advanced Menu, select Diagnostics. This opens the Diagnostics page.
2. Click Ping Test. This opens the Ping Test page.
3. Change or leave the default settings for the following fields:
IP address to ping
Packet size
Number of echo request